RailCoreII Prints

Furthest I've got so far on the #joelbot with the kossel. Looks like my retraction settings were to blame. Should have dialed them in right after switching to @captubes. pic.twitter.com/N2fsMQBQp5

— Joe Mike Terranella (@MoeJike) November 8, 2017

Still dialing DOWN my retraction with this new @captubes setup. Before it was 5.5mm and I'm this is at 2.5... ON A KOSSEL! #mindblown pic.twitter.com/ljx3YoL3LK

— Joe Mike Terranella (@MoeJike) November 8, 2017

First print with @captubes was successful! They installed perfectly seem much sturdier than the previous ones pic.twitter.com/vshqBMPBeZ

— Lauren Renee (@AbuzzDesigns) November 8, 2017

@barb_3dprintny I am loving this fkexy2- transparent tpu & since adding @captubes, the improvement rocks. 85a with retractions! #3dprinting pic.twitter.com/vvUx19ng1B

— Rae (@theplasticowboy) November 4, 2017

430mm still going ! pic.twitter.com/tH0s7tA6SJ

— Happy Extruder (@HappyExtruder3d) November 8, 2017

Shipments from @PrintedSolid and @captubes today. Time to get the MK2S up and going again! pic.twitter.com/WgJL6WVpyb

— Joe Mike Terranella (@MoeJike) November 6, 2017

Loving this Bowden tube from @captubes! Can't wait for the 2.85mm version so I can upgrade my Ultimaker 😋 pic.twitter.com/kT3IDfNSvT

— Avery (Avery's Tech) (@averys_tech) November 2, 2017

You're in good company @captubes pic.twitter.com/pIyHOHOoMp

— Tinkerz (@_Tinkerz) November 2, 2017

Little @captubes captube from @E3DOnline this morning and #3dphil 😀 pic.twitter.com/SzY7C93XvO

— Gareth (@bobblejot) November 1, 2017

Gotta say, love the color of this @captubes ptfe tube from @PrintedSolid! #blue pic.twitter.com/LnDCfjLN3d

— Joe Mike Terranella (@MoeJike) October 31, 2017

Mesh leveling firmware, @captubes Bowden, and authentic @E3DOnline hot end has our CR10S running great! pic.twitter.com/JHGYsXVW8f

— Printed Solid (@PrintedSolid) October 12, 2017

@joeltelling @Barnacules would be interesting to get your hands on review of my DaVinci 1.0 upgraded to E3Dv6, maybe MRRF18, thnx @captubes pic.twitter.com/02HmSkOJHa

— Chris Riley (@RiloMoBo) April 11, 2017